Publicidad
Idiomas disponibles
Idiomas disponibles
If you configure the module to operate in ALAR. mode, define now the zones to which the message has to be sent by means
of the jumpers highlighted in nr.3. For example: If you wish the module to act in zones 3 and 5, insert two jumpers at
position J111 and J119.
Set the microphones input sensibility with the jumper marked with nr.4: ATT -30 dBv /1K8Ohm ; NOT ATT -50dBv
/1K8Ohm.
Insert and screw the module and the chassis together in the front and back panels.
Connect the data buses (Flat 10- and 20-way cables) to the connectors marked with nr.5 in the figure on next page.
Link together the front and back panel. In this case you will have to connect following connector pair marked with nr. 6:
J123-TS101.
Once the complete installation of one or various chassis and the peripherals connections to ENVIRO has been carried out,
you should adjust the volume of this module so that the
final step in the modules configuration, you may wish to adjust the tone controls.
MMT1 MODULE
6
MMT1
2/2
SIGNAL LEVEL
1
PRIORITIES:
Priority 1: J103-J106
Priority 2: J104-J107
Priority 3: J105-J108
3
LED lights up green while talking normally. As the
5
2
4
www.audiovias.com
50.0038.01.00
Publicidad
