Installation And Connection; Connecting To The Power Supply - Trevi SB 8300TV Manual De Uso

ENGLISH SB 8300TV
NOTES ON USE
This is a precision electronic appliance; avoid using it in the following cases:
- Near strong heat sources, such as central heating plants or stoves.
- In very humid places such as bathrooms, swimming pools, etc.
- In very dusty places.
- In places subject to strong vibrations.
- Position the appliance in such a way that there is always enough room for free air circulation (at least 5 cm).
- Do not block the air inlets.
- If any liquid enters the appliance, unplug it immediately from the socket and take it to the nearest TREVI authorised service centre.
- Before switching on the appliance, always check that the power cable and the connection cable are properly installed.
CARE AND MAINTENANCE
Use a slightly damp soft cloth for cleaning. Do not use solvents and abrasive substances.
IMPORTANT
This appliance has been carefully built to ensure long-lasting perfect performance. However, should any inconvenience occur, please contact your
local authorised TREVI Service Centre.
TREVI follows a policy of ongoing research and development. Therefore products may have different features from those described.
DESCRIPTION OF CONNECTORS/CONTROLS
Unless otherwise specified, the controls description applies to both the appliance and the remote control.
1. Volume Up button
2. Volume Down button
3. 3D button
4. On/Standby button
5. LINE IN socket
6. MUTE button (on remote control only)
7. On/Standby LED indicator
8. Remote sensor
REMOTE CONTROL BATTERY ACTIVATION AND REPLACEMENT
The remote control features a CR2025 battery.
To activate the remote control battery (supplied therein), remove the protective plastic tab.
To replace the battery:
1. Remove the battery compartment in the arrow direction (see the picture in rear case of remote control).
2. Replace the battery with one of the same type (CR2025).

INSTALLATION AND CONNECTION

1. Connect any type of appliance featuring an audio output to the LINE IN socket (5) using a 3.5 mm jack plug cable.
2. Switch the appliance on.
3. Control the external unit with its controls.

CONNECTING TO THE POWER SUPPLY

Fit the plug into an AC 220V - 50Hz socket. Do not plug the appliance to different power.
Unless otherwise specified, the controls description applies to both the appliance and the remote control.
STANDBY
1. Press the power-on/standby key (4) to activate the appliance.
2. Press the power-on/standby key (4) again to switch the appliance back to standby mode.
4