Fracarro SIG7330 Instrucciones De Uso página 26

5.2.7 HEADEND SETUP AND KTP EMULATION MENU
Navigation in the headend
programming menus
HEADEND
SETUP
On Screen Display settings
visualization
Automatic
acknowledgement of the
headend connected to
the TPE
Export the headend
configuration to another one
Restore the module
defaults setting
Restart the module
KTP
EMULATION
* The function copies the following parameters: TS input, LNB, DiSEqC, IF Freq., Symbol rate, TS output,
Video format, Audio type, Audio level, Standard. The settings relevant to the channel list will not be cop-
ied.
To update the firmware of the SIG7330 modules, refer to the download section of our Internet web site www.
fracarro.it.
The following is a summarizing table of a few useful suggestions for the diagnosis and solution of possible mod-
ule problems.
Problem
Red Led ON
Audio/Video Output missing
Freezing output signal
NAVIGATION
NAVIGATION OSD
HEADEND SCAN
COPY
FACTORY SETUP
SET ADDRESS
RESET MODULE
KTP Emulation
Emulation of the KTP
programmer
KTP
EMULATION
Confirm the settings by pressing the
pressing the S key after the modules programmation.
6. FIRMWARE UPDATING INSTRUCTIONS
7. TROUBLESHOOTING
Explanation
General malfunction
1. RF Input signal trouble
2. Input wrong setting
RF input signal too low
Refer to the SIG7330 general
SIG7330
programming menu
Refer to the SIG7330 general
SIG7330
programming menu
Search module....
Paste
Copy
SIG7330
SIG7330
All
SIG7330
modules
Address not valid
All
SIG7330
modules
V=OUTPUT
key; save the settings by
Contact FRACARRO Technical Support
1. Check the aerial connection
2. Check the frequency input setting
Check the RF signal level by using a field
meter
26
Automatic search of the headend or
the connected device. After
searching, the main menu can be
seen from the NAVIGATION function
*
YES = V NO = X
Yes=V NO=X
Read-only
Yes=V NO=X
The function is not
available for the
programming of the
SIG7330 module
Solution