Publicidad
Idiomas disponibles
Idiomas disponibles
PLEASE READ AND SAVE THESE INSTRUCTIONS. READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE,
OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION.
FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! RETAIN
INSTRUCTIONS FOR FUTURE REFERENCE.
BEFORE YOU BEGIN
WARNING
!
Installation, trouble shooting, and
replacement of parts are to be performed
only by authorized service technicians.
Electrical Requirements
• The motor amperage and voltage ratings must be
checked for compatibility to supply voltage prior to final
electrical connection. Please refer to the motor's
nameplate label.
• Wiring must conform to local, state, and national codes.
Tools / Materials Needed（Not Included）
• (8) Fasteners - suitable for mounting frame type.
• Sealant or Caulk
• Screwdriver compatible to fasteners
Fans are UL/CUL Listed, Standard 705.
1. Do not depend on any switch as the sole means of
disconnecting power when installing or servicing the fan.
2. Always disconnect, lock-out, and tag-out power source
before installing or servicing. Failure to disconnect power
source can result in fire, shock, or serious injury.
3. Motor will restart without warning after thermal protector
trips. Do not touch operating motor; it may be hot enough
to cause injury.
4. Do not place body parts or objects in fan or motor
openings while motor is connected to the power source.
5. All electrical connections should be made by a qualified
electrician.
6. These utility exhaust fans are for general purpose
exhaust applications only. Do not use these exhaust fans
in an area where corrosive or explosive materials may
be found.
7. Follow all local and state/provincial electrical and safety
codes in the United States and Canada, as well as the
National Electrical Code (NEC) and the Occupational
Safety and Health Act (OSHA) in the United States, and
the Canadian Electric Code (CEC) in Canada.
8. Always disconnect power source before working on or
near a motor or its connected load.
9. Protect the power cable from coming in contact with
sharp objects.
10. Do not kink or create tight bends in the power cable
and never allow the cable to come in contact with oil,
grease, hot surfaces, or chemicals.
Corrosion Resistant
Shutter Mount Exhaust Fan
GENERAL SAFETY INSTRUCTIONS
UNPACKING
Contents:
• Shutter Mounted Exhaust Fan
• Owner's Manual
Inspect:
•• After unpacking fan, carefully inspect for any damage
that may have occurred during transit. Check for loose,
missing, or damaged parts.
• Check all screws and fasteners for looseness that
may have occurred during transit. Tighten as needed.
Rotate propeller by hand to ensure it turns freely.
• See General Safety Instructions as below, and
Cautions and Warnings as shown.
11. Make certain that the power source conforms to the
requirements of your specific exhaust fan model.
The fan frame and motor must be electrically
grounded to a suitable electrical ground, such as a
grounded water pipe or ground wire system.
12. To reduce the risk of injury to persons, please
observe the following:
In the United States, OSHA compliant guards are
required when fan is installed within 7 feet of the floor or
working level. In Canada, CSA compliant guards are
required when fan is installed below 2.5 meters (8.2
feet) above the floor or grade level.
2
User's manual
Publicidad
