Twin-Star International 23MM1297 Manual De Instrucciones página 7

5. Insert one Wood Dowel (CC) into each of the
pre-drilled holes.
Locate upper side panels (I, J) on the top of the
assembly from the step 4, as shown in diagram.
Make sure that dowels are seated into the pre-drilled
holes.
Using Bolts (AA) and Washers (BB) attach these
panels through pre-drilled holes in the mounting
blocks.
HAND TIGHTEN ONLY.
Hardware Used
AA
Bolt
BB
Washer
CC
Wood Dowel
6. Insert one Wood Dowel (CC) into each of the
pre-drilled holes on the top edges of the Assembly
from step 5. Then locate Mantel/Top (G) and lay
fi nished side up on top of completed assembly. From
the inside, attach Mantel/Top (G) using Bolt (AA) and
Washer (BB) through the pre-drilled holes in the
mounting blocks.
HAND TIGHTEN ONLY.
Using Phillips head screwdriver tighten all Bolts
alternating top and bottom, left and right.
Hardware Used
AA
Bolt
BB
Washer
CC Wood Dowel
7. Attach Side Back Panels (O) and Center Back Panel
(N) to the back of the completed assembly from step
6. Use a Phillips Head Screw Driver, tighten Wood
Screws (EE) through the pre-drilled holes in the Side
Back Panels (O).
Hardware Used
EE Screw
Fig. 5
J
CC
x 4
x 4
x 4
Fig. 6
CC
x 6
x 6
x 4
Fig. 7
x 46
6
AA
BB
CC
G
CC
BB
AA
EE
N
O
I
O