Important - Kinetico A200 Manual Del Usuario

A200 Drinking Water Sytem
membrane. Close the cold water supply valve after this time. Reconnect the
tubing to the storage tank valve. If the tubing end is scarred or scratched, cut
away the damaged end before connecting it to the tank.

IMPORTANT:

from the membrane. DO NOT drink the water from the system during this
rinsing procedure.
NOTE: The serial number is located on the data plate that is attached
to the inside of the bracket cover. If your system is installed on a
chlorinated water supply, use a high capacity carbon/sediment prefilter
(Part No. 9461A) to remove the chlorine before the membrane.
If your system is installed on a non-chlorinated water supply, use a
sediment prefilter cartridge (Part No. 9309A).
Using a carbon/sediment prefilter on an unchlorinated supply may
cause a bacteria/odor problem.
A200 reverse osmosis systems can only be used for arsenic reduction on
chlorinated water supplies containing detectable residual free chlorine
at the system inlet. This chlorine must be removed with a high-capacity
carbon/sediment prefilter (Part No. 9461A).
I. Remove the sanitizer cartridge from the prefilter head on the left-hand
side of the system and install the new prefilter cartridge
J. Open the tap. Open the cold water supply valve.
K. Open the valve on the tank. The tank should now be discharging water
through the open drinking water tap. This will flush away any carbon fines
from the new postfilter cartridge. When the flow slows to a drip, close the tap.
Allow the system to fill the storage tank for several hours. Discard the water
in the tank after this time. A four (4) tank flush is required per installation
instructions. Allow the system to fill the tank and begin enjoying your clean,
clear water.
10
You must properly rinse the membrane sanitizing solution
.
8