Beper 90.396 Manual De Instrucciones página 9

Cotton Candy Maker Use instructions
USE ADVICE
Make sure that the mains voltage corresponds to the data specified on the label of the
cotton candy maker.
Locate the cotton candy maker on a plane and stable surface, away from heat or cold
source.
Make sure the bowl is well fixed on the motor of the cotton candy maker before use.
Do not put hands into the bowl while operating.
The rotating reservoir turns quickly and with high temperature; to avoid risks of injuries do never
touch with hands, spoons or other.
Do not switch on the cotton candy maker without the rotating reservoir.
Be careful while operating, sugar hits the air.
Leave the cotton candy maker cool down before putting or removing bowl or rotating reservoir.
The temperature of the rotating reservoir is still high for approx. 15 minutes after switch off; do no
touch to avoid injuries and burns.
When switch off the cotton candy maker wait until the rotating reservoir completely stops.
Always hold the cotton candy maker by the body unit and never by the bowl to move it.
Not leave the cotton candy maker connected to the socket without supervision.
Do not leave the cord supply connected on the socket if not used, always disconnect the cotton
candy maker if not used.
Do not pull on the cord supply to disconnect from the socket.
If the cord is damaged, make it replaced asking to the assistance centre authorized.
Do not immerse the cotton candy maker and the cord into water or other liquids.
Do not leave cotton candy into the bowl when the device is switch off and not used for a long time.
Do not expose the cotton candy maker to damp and do not use it outdoors. Do not put liquids into
the cotton candy maker. In case of infiltration, disconnect the plug and make the device repaired by
a professional people.
Do never touch the cotton candy maker and the cord with wet hands.
The cotton candy maker is not for playing.
The cotton candy maker has been manufactured for household use only, and not for commercial
purpose.
DESCRIPTION
1 – Bowl
2 – Rotating reservoir
3 – Heating rods
4 – Body motor
5 – Switch on/off (I/0)
6 – Non-slip feet with sucker
7 – Cord supply
8 – Measuring cup
9