Turning On/Off The Headset; Pair To Your Bluetooth Phone - Anycom MILOS-9 Manual De Instrucciones

3. Turning on/off the headset

Turning on the headset
While the headset is powered down, press and hold MFB until blue LED turns on.
A low tone followed by a high tone will indicate that the headset is powered up. Afterward, blue LED will flash every 3 seconds.
Turning off the headset
While the headset is powered up, press and hold MFB until red LED turns on.
A high tone followed by a low tone will indicate that the headset is powered down.

4. Pair to your Bluetooth phone

Before you use your headset for the first time, you should pair your headset with the device that you want to use with, such as your
Bluetooth phone.
* Before pairing starts, make sure the headset is fully charged and the charging cable is disconnected from it! *
•
While the MILOS-9 is powered off, press and hold MFB until red and blue LEDs flashing alternately.
It indicates that the headset is in Pairing Mode.
•
Follow the operating instructions for your Bluetooth mobile phone to start the pairing process.
Typically, this has to be done by going to a setup or connect menu and then selecting the options to discover Bluetooth devices.
It may take several seconds to establish a connection.
•
Your phone's display should indicate that it has found the "MILOS-9" headset and asks if you want to pair it.
You should confirm this. The phone's display would prompt you for a passkey or PIN. Enter a sequence of "0000".
•
The headset LED will flash blue every 3 seconds, indicating successful pairing. Usually the phone will also ask whether you want
to change the headset's name. We recommend keeping the default name MILOS-9 instead of changing it.
•
If pairing does not occur as expected: Turn off both the headset and the phone and wait for 10 seconds. Turn on the headset and
phone again and repeat all steps from beginning. Pairing does authorize the devices like mobile phones and headsets with each other
and only needs to be performed once.
Establishing Bluetooth link
After successfully pairing the MILOS-9 and the mobile phone, you may need to establish a Bluetooth link between them according to the
operation manual of your mobile phone. To establish the link, press MFB shortly.
Use Nokia 6130i as an example, the mobile phone will show "Do you accept MILOS-9 request for connection?" Select YES to establish the link,
then you are ready to make and answer calls on the headset. For other phones, please follow the operation manual to establish the link.
You are ready to make and answer calls on the headset.
Page 4
English - Milos-9