Important Safety Instructions; Grounding Instructions; Electrical Requirements - GE KITCHEN HUB UVH1301 Manual Del Propietario E Instalación

IMPORTANT SAFETY INSTRUCTIONS

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the
electric current. This appliance is equipped with a cord
having a grounding wire with a grounding plug. The
plug must be plugged into an outlet that is properly
installed and grounded.
WARNING
Improper grounding can result in
a risk of electric shock.
Consult a qualified electrician if the grounding
instructions are not completely understood, or if doubt
exists as to whether the appliance is properly grounded.
Do not use an extension cord. If the power supply
cord is too short, have a qualified electrician install
an outlet near the appliance.
Where a standard two-prong wall receptacle
is encountered, it must be replaced with a
properly grounded three-prong wall receptacle,
installed by a qualified electrician.
WARNING
Risk of Electric Shock.
Can cause injury or death: DO NOT, under any
circumstances, cut, deform or remove any of the
prongs from the power cord. Failure to comply
may cause fire.
10
Installation Instructions
CAUTION
For personal safety, the
mounting surface must be capable of supporting
the cabinet load of this 75 pound product.
CAUTION
For personal safety, this product
cannot be installed in cabinet arrangements such
as an island or a peninsula. It must be mounted
to BOTH a top cabinet AND a back wall.
CAUTION
To avoid the risk of personal
injury (back injury or other injuries due to
excessive weight of the product) or property
damage, you will need two people to install
this product.

ELECTRICAL REQUIREMENTS

120 V Models
This product requires a three-prong grounded
outlet. Product rating is 120 volts AC, 60 Hertz.
This product must be connected to a supply circuit
of the proper voltage and frequency. Wire size
must conform to the requirements of the National
Electrical Code or the prevailing local code. The
outlet box should be located in the cabinet above
the unit and away from any potential ducting. The
outlet box and supply circuit should be installed by
a qualified electrician and conform to the National
Electrical Code or the prevailing local code.
49-2000492 Rev. 2