installation instructions
1.
Remove contents from box.
2.
Attach red handle by threading plastic
screws through the bottom of the bench
and tightening.
3.
Attach rubber grips by threading the plastic
screws through the top of the bench and into
the rubber grips, making sure the grey rubber
side faces outward. This will be the side that
makes contact with the bath tub.
Do not tighten.
4. Place the shower bench in the tub with the
red handle on the outside. This handle
provides support into and out of the tub.
5.
Move rubber grips flush against the side of
tub and tighten screws.
6.
Make sure bath bench is secure before
each use.
NOTE: to maintain to the beauty of the original
finish, clean with mild soap and rinse with warm
water. Wipe shower bench dry after each use.
WEIGHT CAPACITY: 250 LBS (113 KG)
Rev.2.02.18.14
lifetime limited
warranty
Your Drive branded product is warrantied to be
free of defects in materials and workmanship for
the lifetime of the product for the original con-
sumer purchaser.
This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confi-
dence in the materials and workmanship of our
products and our assurance to the consumer of
years of dependable service.
This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable
components,
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
© 2014 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China
such
as
rubber