Westfalia 321 407 Instrucciones De Montaje página 25

Installation Instructions:
1.) Remove rear bumper and deformation elements from left and right of vehicle. Cut out plastic
bumper according to inner marking (roughened horizontal surface).
2.) Insert towing bracket 'A' together with bumper into opening of rear end plate so that holes
'a' are aligned with fixture points on vehicle.
Insert enclosed M 10 bolts and tighten. (Bolts are of strength class 10.9 / 100).
3.) At point 'e' (only for Golf - 4-Motion), insert from the side and tighten the additional 2 bolts
provided by Westfalia (strength class 10.9 / 100).
4.) Secure socket holder 'B' with assembled electrical set at 'f' with two M 6 nuts.
Important: The electrical set can only be installed with the towing bracket.
5.) Tighten all bolts and nuts uniformly.
Tightening torque:
6.) Refit plastic bumper with standard bolts. Deformation elements are no longer required for
vehicles with towing bracket.
The cover provided as standard for the cutout in the bumper cannot be used with this
towing bracket.
M6 8 Nm (strength class 8)
M10 55 Nm (strength class 10)
GB
Subject to alteration.
25