During Operation - Stiga VE32 Instrucciones De Uso

EN

1.5 During operation

WARNING! The rotating tool is sharp.
Pay attention to the safety distance specified in the
safety regulations.
Only start the motor when your feet are a safe dis-
tance from the rotating tool.
Always make sure you have a safe footing, espe-
cially on slopes. Never run, always walk slowly.
Never use the machine on steep slopes.
Hold the cable away from the rotating tool when
you are operating the machine.
Always move the machine sideways along the
slope, never up and down.
Switch off the machine when tilting or transport-
ing.
Never use the machine in the absence of protective
equipment or a protective cover.
Before lifting or moving the machine, switch off
the motor and wait until the rotating tool has come
to a complete standstill.
Before removing the grassbox or adjusting the op-
erating height, switch off the motor and wait until
the rotating tool has come to a complete standstill.
Replace worn or damaged blades as a complete set.
See the installation instructions. Always use genu-
ine spare parts. Cleaning and maintenance of the
machine may only be performed when the ma-
chine's power supply is completely switched off.
Never store the machine in damp environments or
close to an open flame.
If the machine has run over a hard foreign object,
it must be examined by a specialist for safety rea-
sons (see list of dealers).
If the connection cable has been damaged during
use, it must immediately be disconnected from the
power supply. Do not touch the cable until the
power has been disconnected.
30
ENGLISH
2 GENERAL
This symbol indicates WARNING. Per-
sonal injury and/or damage to property
may result if the instructions are not
followed carefully.
Before commencing installation, care-
fully read these instructions and safety
instructions.
2.1 Symbols
The following symbols appear on the machine.
They are there to remind you of the care and
attention required during use and maintenance.
This is what the symbols mean:
Warning!
Read the instruction manual and the safety
instructions before using the machine.
Warning!
Keep spectators away. Beware of objects
being flung out.
Warning - rotating blades!Do not put
hands or feet under the cover of the
machine when it is running.
Warning - rotating blades!
The blades will continue to rotate after the
machine has been switched off.
Warning!
Remove the plug from the wall socket
before carrying out any kind of
maintenance.
Warning!
Keep the supply flexible cord away from the
tines!
Never run over the extension lead. Risk of
fatal electric shocks.
Warning!
Wear safety gloves, safety goggles and
hearing protection.
2.2 References
The figures in these instructions for use are num-
bered 1, 2, 3, etc.
Components shown in the figures are marked A, B,
C, etc.
A reference to component C in figure 2 is written
"2:C".