Vehicle Preparation; Schablonen - BMW F 36 0034 B Instrucciones De Montaje

Supplementary Kit Rear Speakers
for BMW 3 Series (E36/7) Z3 roadster
These installation instructions only apply to vehicles with stereo provisions or with stereo equipment up to
production date 4/97.
a
For effective sound optimisation, the sound module system can be
additionally installed for BMW 3 series (E36/7) Z3 roadster.
The rear speakers should be installed before installing the sound module system.
Intended for use in BMW dealer organisation only.
Installation time 1.5 hours.
The installation time can vary depending on the edition and equipment of the vehicle.
Knowledge of the body electrical system is required.
b
Take particular care to ensure that cables and wires are not bent, kinked or damaged when installing in the
vehicle. Jumpers, double crimp connections or parallel connections should be used if specified pin chambers are
already used.
Item numbers only refer to the overview or to the text below the corresponding figure.
Subject to technical modifications
Required tools and other equipment
1/4 inch set of sockets
Inspection lamp
Set of screwdrivers for recessed crosshead screws
Textile adhesive tape
Power drill
Set of Torx wrenches
Contents
Section

1. Vehicle Preparation

2. Overview of Installation Kit
3. Connection Overview of Auxiliary Wiring Harness
4. Installing Auxiliary Wiring Harness
5. Installing Rear Speakers
6. Connecting Auxiliary Wiring Harness
7. General Information
8. Encoding
9. Function
10. Schematic
11. Templates
1. Vehicle Preparation
– Print out fault memory
– Disconnect battery
– Remove radio
– Remove centre console
– Remove rollover bar (if fitted)
– Remove both B-pillar trim panels at top
– Loosen centre oddments tray at rear
– Remove both B-pillar trim panels at bottom
10
Side cutter
Set of screwdrivers for slotted head screws
Set of twist drills
Pneumatic compass saw
Angle grinder
Set of files
c