Publicidad
Idiomas disponibles
Idiomas disponibles
Step 6:
A. Flip the
Mattress Support (C)
missing, the correct orientation is with the springs at the top of the frame.
B. With a helper to hold it at the right height, align the screws on the Mattress Support (C)
with the holes on the crib sides and tighten with the allen wrench. There are three possible
height positions. The support should start at the high position for newborns, then be moved
lower as the child grows and becomes more mobile. Once the child is able to pull up to a
standing position, the support must be set to its lowest position.
so the "This Side Up" label is facing up. If the label is
Thread and tighten
all four screws
Middle Position
Low Position
(C) Mattress Support
Label reading "This Side Up" should
be facing up
High Position
Publicidad
