General Safety Instructions; Instruction Manual - AEG SLS 4700 Instrucciones De Servicio

General safety instructions

To avoid the risk of fi re or an electric shock, you should
not expose the device to rain or moisture. Consequently,
do not use the device in the immediate vicinity of water
- for example near a bath tub, a swimming pool or in a
damp cellar.
Use the device only for the intended purpose.
Only connect the device at a properly installed plug
socket. Pay attention that the specifi ed voltage corres-
ponds to the voltage of the plug socket.
When using external mains supply, pay attention to the
correct polarity and voltage. Always place the batteries
in the correct direction.
Assemble the device in such a way that the available
ventilation openings are not covered.
Never open the housing of the device. Incorrect repairs
can constitute a considerable risk for the user. Should
the device become damaged, in particular the mains
supply cable, do not operate the device any longer, but
rather have it repaired by an expert. Check the mains
supply cable regularly for damage.
For safety reasons a broken or damaged mains lead may
only be replaced by an equivalent lead from the manuf-
acturer, our customer service department or a similary
qualifi ed person.
If the device is not used for a longer period, remove the
plug connector from the plug socket or take out the
batteries.
These symbols may be found on the machine and are
intended to indicate the following:
The lightning symbol should advise the user
of parts in the inside of the device which carry
dangerously high voltage levels.
The symbol with an exclamation mark should
advise the user of important operation or
maintenance instructions in the accompa-
nying documentation.
Devices bearing this symbol work with a
„class 1 laser" for tracing the CD. The built-in
safety switches should prevent the user being
exposed to dangerous laser light, which is
invisible to the human eye, when the CD compartment
is opened.
Under no circumstances should these safety switches
be bypassed or manipulated, as this could result in a
danger of exposure to the laser light.
Installation
• Remove all devices from the packing and replace the
internal packaging material back in the box.
• Retain the packaging if possible during the entire gua-
rantee period!
• Do not insert the plug of the subwoofer into the socket
until all loudspeakers and connections have been cor-
rectly made!
For optimum installation of the loudspeakers, please
follow the instructions below:
Installing the Loudspeakers
1. Connect the base plate to the loudspeakers with the
fastening materials supplied.
2. Now connect the loudspeaker cable supplied to the
loudspeaker. Ensure the correct polarity (connect
black to black and red to red).
3. The cinch plug of the loudspeaker cable is now
connected to the AUDIO OUTPUT of the subwoofer
according to the loudspeakers.
Connection
Note: Please ensure that the plug connections are firm.
Bad connections may lead to poor sound quality.
1 2CH INPUT: Used for connecting an external sound
source via cinch (e.g. hi-fi video recorder).
2 5.1CH INPUT: Used for connecting an external sound
source to a 5.1 output (e.g. DVD player).
3 AUDIO OUTPUT: Outputs on the right and left
for connection of the front loudspeakers (FRONT
RIGHT/ LEFT).
Output for connection of the centre loudspeaker
(CENTER).
Output for connection of the surround loudspeakers
on the right and left (REAR RIGHT/ LEFT).
4 Mains lead
25