Status Indications - Velleman VM165 Instrucciones De Uso

Status indications

STATUS INDICATIONS
LD1 and LD2 blink during the internal self-test procedure after the powering up the dimmer module.
8
Blinking:
LD3
Off:
"Input
control"
On:
Off:
Flash 1x
Flash 2x
LD2
Flash 3x
"Error"
Flash 4x
Flash 5x
The dimmer module is defective if the connected lighting burns directly at maximum brightness when
powering the dimmer module without control voltage. Contact your Velleman repair service.
Shortly interrupt the power voltage supply to the module to switch to normal operation after an error
indication.
Slow blinking:
LD1
Fast blinking:
"Dim status"
Very fast blinking:
Operation OK (analogue input voltage conversion )
A/D converter failure.
Malfunction in A/D converter. Restart module. Module is defective when
error repeats.
Normal operation.
Internal error: Check voltage and connections.
Internal error: Check voltage and connections.
Error Triac Check connected light bulb, lamp group and/or trans-
control: former.
Measured phase shift is too important. Check connected light bulb,
lamp group and/or transformer.
Internal communication error and/or incorrect power connection
(jumper between 2 pins of N115 or N230).
Stand-by, brightness is 0%.
Dimmer active, brightness between 1 and 99%.
Dimmer active, maximum brightness.