Mitsubishi Electric Mr.SLIM PLA-A.EA7 Manual De Instrucciones página 9

. Operation
.5.2 ane ent. Lossnay
Accessing the enu
Main Main menu
Vane·Louver·Vent. (Lossnay)
High power
Timer
Weekly timer
OU silent mode
Main display:
Cursor Page
F1 F2 F3 F4
ane setting
Fri
Swing Off
Vane Vent. Louver
F1 F2 F3 F4
ent. setting
Fri
Low
Vent.
F1 F2 F3 F4
Returning to the Main enu
Main Main menu
Vane·Louver·Vent. (Lossnay)
High power
Timer
Weekly timer
OU silent mode
Main display:
Cursor Page
F1 F2 F3 F4
Notes:
During s ing operation the irectional in ication on the screen
oes not change in sync ith the irectional anes on the unit.
A aila le irections epen on the type of unit connecte .
In the follo ing cases the actual air irection
irection in icate on the re ote controller isplay.
1. While the isplay is in STAND Y" or DEFROST" states.
2. I e iately after starting heat
ing for the o e change to ta e effect .
. In heat o e hen roo te perature is higher than the te -
perature setting.
Select "Vane·Louver·Vent.
(Lossnay)" from the Main menu
(refer to page 8), and press the
[SELECT] button.
Press the [F1] or [F2] button to go
through the vane setting options:
"Step 1", "Step 2", "Step 3", "Step
4", "Step 5", "Swing" and "Auto".
Select the desired setting.
Step 1 Step 2 Step 3
Swing
Step 4 Step 5 Swing
Auto
Auto
Select "Swing" to move the vanes
up and down automatically.
When set to "Step 1" through "Step
5"
selected angle.
Press the [F3] button to go through
the ventilation setting options in the
order of "Off", "Low", and "High".
* Settable only when LOSSNAY
unit is connected.
Off Low High
Off Low High
units may be interlocked with
certain models of ventilation units.
Press the [RETURN] button to go
back to the Main menu.
ill iffer fro the
o e hile the syste is ait-
Ho to set the e up o n air irection
Note:
This function cannot e set epen ing on the out oor unit to e
connecte .
For PLA-A·
DOWN air direction setting of remote controller.)
E planation of or
"Refrigerant address No." and "Unit No." are the numbers given to
each air conditioner.
"Outlet No." is the number given to each outlet of air conditioner.
(Refer to the illustration below.)
Remote controller setting
-
tion setting of remote controller.
Outlet No. 2
Outlet No. 1
Note:
The outlet No. is in icate y the nu
en s of each air outlet. Set the air irection
infor ation sho n on the re ote controller isplay.
Fixed
in particular direction.
* When it is cold because of direct
Outlet No. 3
Outlet No. 4
er of groo es on oth
hile chec ing the
9