Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Packaging and scope of delivery
Remove the packaging from the radiator
►
(Fig. 2).
Inspect the contents of the soil stand brack-
►
et package for completeness and damage.
10
2b
Description
1
Bracket base
2a Supporting pipe T22
2b Supporting pipe T33
3
Lug plate
4
Sealing cap
5
Bracket block
6
Support
7
Hook
8
Washer
9
Hexagon nut
10 Grub screw
Number of soil stand brackets
Use the indicated number of soil stand
►
brackets for installation in accordance with
the steel panel radiator's length (Fig. 3).
Observe all information, especially the
►
technical data and limitations on use.
►
Transport and store only in the protective
packaging.
Pre-assembly of the soil stand bracket
Prepare tools and fixing material (screws,
►
washers and anchor) (Fig. 1).
4
►
Insert the sealing caps (4) into the two end
openings of the supporting pipe (2a/2b)
(Fig. 4).
Insert the bracket block (5) into the open-
►
ings provided in the supporting pipe (2a/2b)
(Fig. 4).
Slide the pre-assembled supporting pipe
►
onto the bracket base and adjust a dis-
6
tance of 150 mm from the finished floor
3
(Figs. 5/6).
Using the grub screws (10), fix the support-
►
7
ing pipe hand-tight (Fig. 6).
1
Insert the support (6) into the top of the
►
5
bracket base (recess facing toward the
4
front) (Fig. 6).
2a
For the installation dimensions of the soil
►
8
stand brackets on the radiator, refer to the
9
table in Fig. 7.
4
Installing brackets
Align the soil stand brackets on the floor at
►
the specified spacing and mark the holes to
be drilled (Fig. 8).
Drill the holes at the marked locations
►
(Fig. 9).
Place the soil stand brackets in position,
►
align and, using suitable anchors, wash-
1
1
ers and screws (4 screws per bracket, max.
1
–
Ø 10 mm), fasten the brackets to the floor
–
1
(Fig. 10).
1
1
2
2
Installing the radiator
2
2
Carefully place the radiator on the bracket
►
1
1
bases (Fig. 11).
1
1
Attach the lug plates (3) to the top of the
►
1
1
radiator at the same position as the soil
1
1
stand brackets (Fig. 12).
2
2
Attach hook (7) to the lower lug on the
►
lug plate (3) and insert hook through the
oblong hole in the supporting pipe (2a/2b).
Using the hexagon nut (9) and the washer
(8), fasten hook hand-tight (Fig. 13).
After loosening the grub screws (10)
►
and the hexagon nuts (9), align the ra-
diator horizontally. Then tighten the grub
screws (10) and the hexagon nuts (9) again
(Figs. 13/14).
Cover the radiator completely again with
►
the packaging (Fig. 15).
Publicidad
Tabla de contenido
