Reversing The Door - Polar Refrigeration CE202 Manual De Instrucciones

Telephone Helpline: 0845 146 2887 (United Kingdom)
Installation
Note: If the appliance has been moved or stored in a non-vertical position, stand it in an
upright position for approximately 12 hours before operation. If in doubt allow to stand.
Remove the appliance from the packaging and the protective film from all surfaces.
1.
Avoid positioning the wine cooler in direct sunlight or damp areas.
2.
When positioning the wine cooler, maintain a distance of 20cm (7 inches) between the appliance and
3.
walls or other objects for ventilation. Increase this distance if the obstacle is a heat source.
If necessary, adjust the screw legs of the wine cooler to make it level.
4.

Reversing the Door

Depending on the location of the appliance, it may be necessary to change the direction the door of the
wine cooler opens by changing the side of the door handle.
To reverse the door handle:
Ensure the appliance is disconnected from the power
1.
supply.
Tilt the appliance back slightly and prop it securely.
2.
The appliance must not be tipped back by more than
45 degrees.
Unscrew the door hinge screws on the base of the
3.
door and remove the Hinge.
Open the door slightly and remove the door in a
4.
downwards direction.
Remove the screw cover from the top of the wine
5.
cooler with a small screwdriver.
Unscrew and remove the door frame Pin and Spring
6.
from the top of the appliance.
Screw the door frame Pin and Spring to the opposite
7.
side of the appliance and reattach the screw cover.
Fit the door into place by locating the upper Pin first
8.
then closing the door.
Reattach the hinge pin bracket onto the opposite side of the door.
9.
The appliance can no be lowered into position.
10.
2
Screw cover Spring Pin
Hinge
UK