Mounting The Appliance - Ondal Acrobat 2000 WA04/75 Instrucciones De Montaje

3

Mounting the appliance

Only mount appliance in
position A
3 Mounting the appliance
Please be sure to observe the safety information in section 1.
3.1 Preparing for mounting
Figure 3
WARNING – Sudden release of spring arm

High spring tension develops when the spring arm
down.

Only mount / dismantle the spring arm
locked position A (see section 4.1)..
1. If necessary, limit the height of the spring arm
position A as described in section 4.1.
2. Unscrew countersunk screw M3 x 8 mm
3. Lift up the locking sleeve
4. Remove the locking segment
5. Remove the protective cap
for servicing) at a later date.
3.2 Mounting the appliance
Figure 4
1. Insert the spigot of the appliance
segment
2. Turn the sleeve
countersunk screw M3 x 8 mm
WARNING – Falling appliance
Lock sleeve
3. Screw in countersunk screw M3 x 8 mm
4. Check that the appliance
5. Set height limit, load capacity and brake power as described in the
Acrobat 2000 Operating Instructions.
:
a little, turn it to the right and slide upwards.
with a narrow slot-head screwdriver.
and keep it for sealing the spring arm
into the spring arm
.
a little to the left and slide downwards until the
can be fitted.
with countersunk screw M3 x 8 mm
is securely in place.
17
is pulled
in the horizontal,
to the horizontal
.
, insert locking
.
and tighten.
GB
B
D
(e.g.