Motor Protection; Emergency Stop - Stiga BioQuiet Instrucciones De Uso

You are recommended to use an earth leakage
circuit breaker which interrupts the current in the
event of something happening to the machine or
connection cable.
If a portable earth leakage circuit breaker is used,
it should always be placed between the electric
socket and the connection cable.
Even if an earth leakage circuit breaker is used,
safety cannot be guaranteed. Always follow the
safety instructions provided. Ideally wear shoes
with thick rubber soles.
Test the operation of the earth leakage circuit
breaker before each use.
In the event of unfavourable electrical mains
conditions, brief voltage drops can occur when you
start the apparatus which can affect other
appliances (e.g. causing lights to flicker).
With a mains impedance of Z
disturbances are unlikely.
STARTING AND STOPPING THE
MOTOR
Ensure that the grinder is empty before
starting the motor.
The motor rotation must be completely
terminated before the motor is allowed
to be restarted.
1. Check that the twist switch (H) in fig. 5 not is
located in its centre position.
Note! The twist switch (H) has three
positions. Only the two outer positions are
used. If the switch is in its centre position, the
grinder cannot be started.
2. Stop the motor by pushing the red stop button
(G) in fig. 5.
CHANGING DIRECTION OF
ROTATION
Never turn the twist switch (H) when the
motor is running!
Change the direction of rotation as below.
1. Stop the motor by pushing the red stop button
(G) in fig. 5.
2. Wait until the spiral cutter has stopped.
3. Set the twist switch (H) in the desired position.
Note! The twist switch (H) has three
positions. Only the two outer positions are
used. If the switch is in its centre position, the
grinder cannot be started.
ENGLISH
< 0,41 ohm, such
max
4. Push and hold the green start button (F) until
the jammed material is refeeded.
5. Wait until the spiral cutter has stopped.
6. Reset the switch (H) and continue the grinding.

MOTOR PROTECTION

The grinder is equipped with a built-in motor
protection (I) which prevents the motor being
overloaded.
In the event of jamming, the current will switch off
after a few seconds and the motor will stop.
Measures at overloading:
1. Wait at least on minut.
2. Reset the motor protection (I) by pushing its
reset button.
3. Feed out the jammed material according to 3-6
above.

EMERGENCY STOP

In order to emergency stop the machine, press the
red pushbutton (G).
DISCONNECT SWITCH
The machine is equipped with a disconnect switch.
This means that the main switch is automatically
disconnected in the event of a loss of current. The
machine can be started again by reconnecting the
plug and turning on the main switch.
GRINDING
The following types of material can be ground in
the compost grinder:
- twigs and branches
- waste from cutting bushes.
- waste from hedge-trimming.
- plant parts and other garden waste which is
suitable for grinding.
Examples of materials which are not suitable for
grinding include:
- glass, metal, plastic bags, stones, fabric, earth-
covered roots.
- waste that does not have a firm consistency, e.g.
kitchen waste.
To prevent damage to the machine, you are
recommended not to exceed the following
maximum sizes of twigs and branches:
< 35 mm diameter for dry, hard material
< 40 mm diameter for fresh, soft material.
EN
29