Attas MIDO 868 Manual De Instrucciones página 8

ENGLISH
2. PROGRAMMING THE HAND TRANSMITTER
2.1 How to program the hand transmitter?
1. Briefly press the pushbutton on the receiver board of the radio receiver. The
LED light on the receiver board starts to flash slowly and signals that the hand
transmitter is ready to learn.
2. Press the desired hand transmitter button as long as the LED light starts
blinking fast.
3. Release the button. Wait until the LED on the radio receiver stops lightning.
The hand transmitter is programmed.
2.2 How to copy an existing hand transmitter?
1. Please be within range of the radio receiver for copying. Hold both hand
transmitters as close as possible to each other. Then press the already
programmed button of the functioning hand transmitter (LED lights up
permanently) and at the same time press the button to be taught in from the
new hand transmitter.
2. The LED of the new transmitter starts to flash. After a few seconds, the LED
of the new hand transmitter flashes faster and then goes out on its own.
3. Release both buttons. The existing hand transmitter has now been copied and
the new hand transmitter is ready for use.
7