Installing The Unit; Important; Tubing Connection - Nikken PIMAG DELUXE 13151 Manual De Instrucciones

Figure 2
Figure 3

INSTALLING THE UNIT

Locate an area under your sink to
place the base.
IMPORTANT: Be sure the base
will be close enough to the faucet
for the tubing to reach both
without being bent or stretched.
INSTALLATION WITH 1/2" PIPE
CONNECTION:
1. Locate the area on the cold
water line for installation of
the two 1/2"adapters (4).
2. Unscrew the pipe from the top
of the stop valve.
3. Thread the correct adapter
(see drawing) into the top of
the stop valve.
4. Thread the connector valve (5)
into the top of the adapter.
5. Thread the other adapter (4)
into the top of the connector
valve.
6. Connect this assembly to the
upper pipe.
7. Press the red tubing (3) into
the adapter.
8. Press the opposite end of the
tubing into the inlet connector
of the stainless steel lid (6), as
shown in Figure 2.
7
INSTALLATION WITH 3/8"

TUBING CONNECTION:

1. Locate the area on the cold
water line for installation of
the connector valve (5).