Safety Instructions; Operating Instructions; Control Panel With Thermostat; Switching On - Truma Ultraheat S 3004 Instrucciones De Uso

Safety instructions

Repairs may only be carried out by an expert.
Due to the design, the heater front case will
become hot during operation. The operator is
obliged to ensure that due care is taken to protect third
parties (small children in particular).
The heater's hot air outlet should under no circumstanc-
es be blocked. Never hang clothes or similar in front of or
on top of the heater to dry. This could cause serious damage
to the heater as a result of overheating. Do not place inflam-
mable materials near the heater! Please observe these instruc-
tions for your own safety.
When operating a brand-new heater for the first time (or after
it has been idle for a lengthy period) you may temporarily no-
tice a slight smoke and smell. We advise running the heater at
full power and thoroughly ventilating the room.
Guarantee claims, warranty claims and acceptance of liability
will be ruled out in the event of the following:
– modifications to the unit (including accessories),
– failure to use original Truma parts as replacement parts and
accessories,
– failure to follow the installation and operating instructions.
Furthermore, the approval for operating the appliance will
become invalid and in some countries also the approval for
operating the vehicle.
Attention: espite careful manufacture, the heating
system may contain sharp-edged components, and pro-
tective gloves should always be worn when carrying out any
maintenance or cleaning work!
6

Operating instructions

Always read the operating instructions before commis-
sioning! The vehicle owner is responsible for correct opera-
tion of the appliance.

Control panel with thermostat

c
230 V ~
a = Rotary switch "Off"
b = Rotary switch "On" power settings:
500 – 1000 – 2000 W
c = Rotary control knob for room temperature
(lit via the green LED "Operating")

Switching on

Before switching on, ensure that the fuse protection for
the power supply of the camp site is sufficient for the
selected power setting (b – see "Technical Data").
Important: The electric feed line for the caravan must be fully
unwound from the cable drum.
To switch on, turn the rotary switch to the desired output
level (b).
The green LED for operation shines and at the same time indi-
cates the selected room temperature setting.
Set rotary control knob (c) to the desired room temperature.
The thermostat setting on the control panel (1 – 9) must be
determined individually depending on the heating requirement
and the type of vehicle.

Switching off

Switch the heating system off at the rotary switch (a).

Disposal

The device must be disposed of in line with the administra-
tive regulations of the respective country in which it is used.
National regulations and laws (in Germany, for example, the
End-of-life Vehicle Regulation) must be observed.
Ultraheat
b
2000
a
b
500
b
1000