1 BY ONE 471NA-0010 Manual De Instrucciones página 5

7. Rotate the counterweight counter clockwise (seen from the front) to adjust the
EN
tracking force according to the cartridge manufacturer's recommendations.
DE
FR
ES
IT
Note: Each mark on the scale represents 0.05g. The recommended tracking force for
the factory-installed cartridge is 3.5g±0.5g. The cartridge only goes up to 2g for one
rotation of the tracking force dial. You will need to make more than one rotation to
reach 3.5g.
Anti-skating Force Adjustment
The anti-skating force must be adjusted corresponding to the tracking force as follows:
Tracking Force Groove in the stick
5-10 mN 1st from bearing ring
10-15 mN 2nd from the bearing ring
15-20mN 3rd from the bearing ring
20mN and bigger 4th from the bearing ring
1. Slip the loop of the anti-skating weight's
3rd
thread over the groove of the stick
to set the correct anti-skating force for
the factory-fitted cartridge.
④ ③ ② ①
2. Feed the thread through the loop of
the wire hanger.
6
Connection to the Speakers
1. Connection to the Included Speakers
This turntable includes a built-in preamp and supplied with Hi-Fi speakers.
Connect the speakers using the included audio cable (black cable to black cable
clamp and red cable to red cable clamp).
2. Connection to External Speakers
If you don't want to use the included speakers and wish to use your own speakers,
please follow below instructions:
2.1 Connection to the Amplifier
This turntable uses a moving magnetic cartridge. Set the PHONO & Line Out
Switch on PHONO position. Connect the phono out cables to the phono
input on your amplifier of pre-amplifier (phono stage). Line inputs such as
CD, Tuner, Tape, or Video are not suitable for phono inputs. Make sure the
amplification of the selected input matches the type of cartridge being used.
The factory installed cartridge is 47k ohms/MM-input.
NOTE: If your amplifier does not have an input suitable for phono cartridges,
you will need to purchase a separate phono amplifier for moving magnetic
cartridges. This separate phono amplifier will then connect between your
turntable and your amplifier.
2.2 Stereo System Connection
Set the PHONO & Line Out Switch on LINE mode. The RCA PHONO & Line Out
Jacks output analog line-level signals and could be connected directly with
a par of active/powered speakers of the appropriate input of your stereo
system.
The Red plug connects with the Right channel and the White plug connects
with the Left channel.
NOTE: The RCA Jacks are not designed to be connected directly to the
passive/unpowered speakers on LINE mode. If connected to the passive
speakers, there is no sound.
7
EN
DE
FR
ES
IT