Remote Sensor (Thn132N); Getting Started; Insert Batteries; Remote Sensor - Oregon Scientific Weather@Home EMR211X Manual De Usuario

REMOTE SENSOR (THN132N)

1
1. LED status indicator
2. Wall mount hole
3. Battery compartment
4. RESET hole
5. CHANNEL switch
REFERENCE Visit our website www.oregonscientific.com
to learn more about the compatible sensors.

GETTING STARTED

INSERT BATTERIES

1. Remove the battery compartment.
2. Insert the batteries, matching the polarities (+/-).
3. Press RESET after each battery change.
LOCATION
Outdoor temperature area
Indoor temperature area
EMR211X_M_EU_EN_R7.indd 3
2
4
3 5
MEANING
Outdoor sensor batteries low
Indoor sensor batteries
low / main unit batteries low
3

REMOTE SENSOR

The main unit can collect data from up to 5 sensors.
To set up the sensor:
1. Open the battery compartment.
2. Select a channel then press RESET.
3. Close the battery door.
4. Place the sensor within 98 ft (30 m) of the main unit
using the table stand or wall mount.
TIP Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 5 ft (1.5 m); and can shield it from direct
sunlight or wet conditions for an accurate reading.
1.5 m (5 ft)
2018/8/15 下午4:29