Technical Specifications - EINHELL ECS12 Manual De Instrucciones

Anleitung ECS 12 02.11.2001 8:03 Uhr
GB
1.
Fig. 1
2.
General:
The electronic code-entry lock consists of a decoder
and a keypad with a flip-open cover.
This code-entry lock is versatile, i.e. it can be used
with our garage door opener keypad function, our
alarm systems, door openers, etc.
When the code word is entered, the switched device
(e.g. garage door opener, etc.) is switched on or off
via a two-conductor wire and a floating relay contact
in the decoder. The decoder is powered by a 9V
monobloc battery (not included) or an external 12V =
DC voltage.

Technical Specifications:

Voltage supply
Standby current:
Ambient Temperature:
Keypad:
Codeword:
Codeword possibilities:
Switch contact:
Housing:
4
°
°
–
12 V=
+
9 V = Monobloc battery
(not included)
or external
12 V = DC Voltage
ca. 60 A
- 25°C bis + 60°C
10 digit/letter keys
max. 12 characters
10
10
floating make contact
element
plastic flip-open cover
Seite 4
Installation:
1.) Determine installation location
Loosen the screws and remove the top of the
keypad housing
Mark the location of the wiring hole using the
housing bottom as a template
Drill a hole of approx. 8 to 10 mm diameter
through the wall
Thread the decoder wire from the inside
through the hole
Mark the location of the mounting holes for the
housing in such a way that the wire can be
threaded through from the rear (see Fig. 2).
Drill the mounting holes and attach the
housing bottom
Properly insert wire plug (see connection plan)
Connection plan
Attention!
The code-entry lock will only function properly if
the connections are installed properly. Attach the
housing top with the keypad to the housing
bottom with the included screws.
2.) Mark the location of the mounting holes for the
decoder on an inside wall
Drill the mounting hole and attach the decoder
(see. Fig. 2).
Attach the decoder wire
Fig. 2
brown