Declaration Of Conformity - JB Systems WBS-20 Manual De Instrucciones

ENGLISH
CLEANING THE APPLIANCE:
Clean by wiping with a polished cloth slightly dipped with water. Avoid getting water inside the unit. Do not
use volatile liquids such as benzene or thinner which will damage the unit.

DECLARATION OF CONFORMITY

RECEIVER: R&TTE Declaration of Conformity
We, Beglec NV, declare under our sole responsibility that the product:
Brand : JB Systems
Product Group : Wireless Receiver
Model n° : WR-10
Meets the essential requirements as described in the R&TTE directive, based on the following standards applied:
EN 300 422-2 : V1.2.2 (2008-03)
EN 301 489-01 V1.8.1 (2008-04)
EN 301 489-09 V1.4.1 (2007-11)
EN 60065:2002+A1:2006+A11:2008
Full test reports and other relevant information remain at the disposal of the Control Agencies at our head office:
Beglec NV ~ 't Hofveld 2c ~ B1702 Groot-Bijgaarden ~ Belgium
Groot-Bijgaarden, July 25th 2009
For Beglec NV,
Luc De Bauw
Director
WIRELESS HAND MICRO : R&TTE Declaration of Conformity
We, Beglec NV, declare under our sole responsibility that the product:
Brand : JB Systems
Product Group : Wireless Transmitter
Model n° : WMIC-10
Meets the essential requirements as described in the R&TTE directive, based on the following standards applied:
EN 300 422-2 : V1.2.2 (2008-03)
EN 301 489-01 V1.8.1 (2008-04)
EN 301 489-09 V1.4.1 (2007-11)
EN 60065:2002+A1:2006+A11:2008
Full test reports and other relevant information remain at the disposal of the Control Agencies at our head office:
Beglec NV ~ 't Hofveld 2c ~ B1702 Groot-Bijgaarden ~ Belgium
Groot-Bijgaarden, July 25th 2009
For Beglec NV,
Luc De Bauw
Director
WIRELESS BELT PACK : R&TTE Declaration of Conformity
We, Beglec NV, declare under our sole responsibility that the product:
Brand : JB Systems
Product Group : Wireless Transmitter
Model n° : WBP-20
Meets the essential requirements as described in the R&TTE directive, based on the following standards applied:
EN 300 422-2 : V1.2.2 (2008-03)
EN 301 489-01 V1.8.1 (2008-04)
EN 301 489-09 V1.4.1 (2007-11)
EN 60065:2002+A1:2006+A11:2008
Full test reports and other relevant information remain at the disposal of the Control Agencies at our head office:
Beglec NV ~ 't Hofveld 2c ~ B1702 Groot-Bijgaarden ~ Belgium
Groot-Bijgaarden, July 25th 2009
For Beglec NV,
Luc De Bauw
Director
NOTE:
WMS-10 wireless set contains: 1pc WMIC-10 + 1pc WR-10
WBS-20 wireless set contains: 1pc WBP-20 + 1pc WR-10
JB SYSTEMS
®
OPERATION MANUAL
7/44 WMS-10 + WBS-20 Wireless system
ENGLISH
SPECIFICATIONS
RECEIVER
Carrier Frequency Range: UHF band
Frequency Stability: 0,005%
Receiving Sensitivity: @ 5μV S/N ratio >80dB
Image and Spurious Rejection: 80 dB minimum
Selectivity:
＞50dB
Modulation Mode: FM
Receiver type:
PLL synthesized, switching diversity
IF Frequency: 1
Tone Signal: 32,768KHz
S/N ratio: ＞94dB, @ 20kHz deviation & 60V antenna input
AF Response: 80Hz to 15kHz (3dB)
T.H.D.: Less than 1,0% (at 1kHz)
Power Supply: DC 12V ~ 18V
Audio Output: Balanced & unbalanced outputs (Mic.= -20dB / Line = 0dB)
Current consumption: 130mA 10mA
HANDHELD MIC / BELT PACK TRANSMITTER
Carrier Frequency Range:
UHF band
RF Power Output: 10mW (max.)
Oscillation Mode: PLL synthesized, 16Channel selectable
Frequency Stability: 0,005%
Maximum Deviation: 20kHz with limiting compressor
Spurious Emission: ＞60dB below carrier frequency
T.H.D.: ＜1,0% (at 1KHz)
Microphone Capsule: Handheld: uni-directional dynamic
Lavalier:
Tone Signal: 32,768 kHz
Battery: DC 3V (2x 1,5V AA size alkaline batteries ) OR
DC 2.4V (2x 1,2V AA size rechargeable batteries)
Current consumption: 120mA 10mA @ 3V
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.beglec.com
JB SYSTEMS
®
OPERATION MANUAL
st nd
: 243.95MHz ~ 2 : 10.7MHz
uni-directional electret condenser unit
8/44 WMS-10 + WBS-20 Wireless system