ARIETE 1769 Manual De Instrucciones página 12

EN
- Plug the appliance into the mains power.
- Start the appliance, selecting the rotation speed of the blade using the operating dial (A).
The appliance has two operating speeds: minimum «1» and maximum «2».
WARNING: When the appliance is used to mix or whisk, we recommend starting at speed "1" and
then passing on to speed "2". When used to chop, it is advisable to use the pulse function, turning
the dial (A) anticlockwise to the "P" setting. For optimum use, press the button in short bursts (2/3
sec.).
WARNING: Never operate the appliance for more than 30 seconds at a time. Wait at least 2 minutes
before operating it again.
- For smoother, finer chopped foods, remove the food, if necessary, from the sides of the bowl with
a spatula, pushing it towards the centre.
WARNING: Never remove foods from the sides of the bowl while the appliance is operating. Switch
off the appliance first and unplug it from the mains power.
WARNING: To prevent accidents or damage to the appliance, always keep hands and cooking
utensils well away from moving blades or discs.
WARNING: Never use your fingers to remove food from the sides of the bowl while the appliance is
operating. Always use the special spatula.
- If it is necessary to add foods during appliance operation, use the opening in the lid (O). Push the
foods down with the pusher (G) on its own (Fig. 8).
WARNING: Never insert foods by hand. Always use the pusher.
- To stop the appliance, turn the dial (A) to "0".
Slicing
WARNING: The blades are sharp; handle with care.
- Fit the required blade, the slicing blade (M), julienne blade (L) or chip blade (N) into the blade
disc (I) so that the hole in the blade is in the centre of the disc (Fig. 9).
- Fit the assembled blade support disc (I) on the motor shaft (C), gripping it by the relevant slots
and keeping the blade so it is facing upwards (Fig. 10).
- Fit the lid (O) over the bowl (P) and proceed as described in the section "Chopping, mixing or
whisking".
CLEANING
WARNING: NEVER PLACE THE APPLIANCE BODY, PLUG OR POWER CORD IN WATER OR
OTHER LIQUIDS; ALWAYS WIPE CLEAN WITH A DAMP CLOTH.
WARNING: ALWAYS UNPLUG THE POWER CORD FROM THE ELECTRICITY MAINS BEFORE
FITTING OR REMOVING SINGLE ATTACHMENTS OR BEFORE CLEANING THE APPLIANCE.
WARNING: The blades are extremely sharp. Always handle them with care.
- Remove all of the attachments used, working in the opposite order to the way they were fitted.
- All attachments can be washed in the top rack of the dishwasher, at a maximum temperature of
50°C/ 122°F.
- Wipe the power base (B) clean with a slightly damp cloth.
- 10 -