Routine Maintenance; Preliminary Checks And Start Up - OP SPEEDY CLEAN Manual De Uso

OP
S.r.l.
________________________________________________________________________________________________________________

ROUTINE MAINTENANCE

• For maintenance and regulation of the cleaning liquid, for the gun, see the
manual enclosed with the machine.
• For best results with the multiplier it is essential to use filtered air. The machine is equipped
with an air preparation unit located just past the compressed air intake connector. This unit
must be checked constantly (for lubrication of the pneumatic parts we recommend using
TELLUS SHELL 22 oil or similar) the regulator for this unit is already calibrated by O+P at a
safe level; any further adjustment could interfere with proper operation of the equipment or
create hazardous situations.
• Check the level of the cleaning liquid periodically and, if necessary, top it up with " Q
E
SOLVENT" through the cap on the tank.
N
• From time to tome, check the efficiency of the multiplier and the tight fastening of
G
couplings and connections.
L
• Change the cleaning liquid in the tank and replace the filter every 500 working hours. The
I
intake filter is installed inside the tank. To access it unscrew the fastening screws (fig.2
S
,pos.1) and remove the cover from the tank.
H
• Every day, check the warning signs for wear and legibility.
• It is very important to have maintenance carried out by trained and qualified personnel who
know how the machine works.

PRELIMINARY CHECKS AND START UP

• Make sure the level of the cleaning liquid is sufficient. Do not exceed the maximum
level indicated. (fig.3, pos.2)
• Switch on the pneumatic supply, maintaining a pressure of 6 bar.
• Perform a function test to make sure everything is working properly with no problems.
25131 BRESCIA - Via Serpente, 97 - Tel. 030/3580401 - Fax 030/3580838
42