Truma DuoComfort Instrucciones De Uso Instrucciones De Montaje página 15

protect the regulator and change-
over valve from the elements.
• Choose a suitable position for
the regulator, in particular: the
type plate is visible, the status
display can be clearly seen,
avoid damage when changing
cylinders, thwart penetration
by gas in the liquid phase, plan
for a place to add the Truma
remote display, avoid tension
in the high pressure hoses.
• Pull the retaining lug for the
dummy cover over the outlet
of the changeover valve.
Duo Com fort
• Connect DuoComfort directly
to the regulator; if necessary
use the Truma angle union
(part no. 50020-56000) or the
Truma extension kit (part no.
50020-61100).
• Attach to the wall with two
screws.
• Screw high-pressure hoses to
the DuoComfort inlets, using
angle unions (part no. 50020-
56000) if necessary.
• After installation is complete,
check the hose connector to
the changeover valve's inlet
and the connection to the
adjacent regulator for leaks
(using, for example, a leak-
detection spray according to
DIN EN 14291).
This test does not replace
the regularly scheduled
gas check!
Accessories
High pressure hoses
(with hose-break safety device)
see page 54 – 55
1.5 meter connection hose
for connecting external gas
cylinders (G.5;
part no. 50020-61300)
Replacement gaskets
for high pressure hoses
(G.13 or M20 x 1.5;
part no. 50020-76300)
Remote display
(including EisEx)
Shows the removal status from
inside the vehicle
(part no. 50210-01)
EisEx, regulator heating
(part no. 53101-01)
Angle union
(part no. 50020-56000)
15