Mounting The Receiver - Silvercrest WD1610 Manual Del Usuario

Wireless Door Bell WD1610
Drill two 6mm holes at a distance of 50mm
-
in the wall.
Insert two of the supplied rawlplugs into
-
these holes.
Insert two of the supplied screws through
-
the holes located in the bottom piece of the
transmitter housing and then screw them
onto the rawlplugs.
- Replace the upper housing piece by
pushing it onto the base unit piece.

Mounting the Receiver

Drill one 6mm hole at the desired position
-
on the wall.
Insert one of the supplied rawlplugs into this
-
hole.
Screw one of the supplied screws into the
-
rawlplug until its head is approx. 2mm away
from the wall.
- Place the receiver onto the screw head.
The wall-mounting hole located at the back
of the housing must completely fit over the
88 - English