Plasmacluster On/Off Button; Lights Control Button; Water Supply Indicator Light; Adjustment Of Sensor Detection Sensitivity - Sharp KC-840E Manual De Uso

OPERATION

Plasmacluster ON/OFF Button

Press the Plasmacluster ON/OFF Button to turn Plasmaclus-
ter Ion Mode ON and OFF.
When Plasmacluster is ON, both the Indicator Light and
Plasmacluster Indicator Light turn on.

LIGHTS CONTROL Button

Use when the light on the
front panel is too bright.
CAUTION
The lights on the front monitor are always brighter when starting.

WATER SUPPLY INDICATOR LIGHT

When the Water Tank is empty, the Water Supply Indicator Light will fl ash
to indicate that the Water Tank should be refi lled. Please note the light
will not fl ash even when the Water Tank is empty during the Clean
Air Mode and the Clean ION SHOWER Mode.
Sound indicator setting for water supply.
In addition to the Indicator Light, the unit can be set to signal with an audible beep when the
Water Tank is empty. With the unit OFF, press the Lights Control button for 3 seconds to turn
the audible signal ON.
Cancellation
To cancel the audible signal, with the unit OFF, press the Lights
Control button again more than 3 seconds.

ADJUSTMENT OF SENSOR DETECTION SENSITIVITY

Set to "low" if the DUST MONITOR and ODOUR MONITOR is constantly red to reduce
sensitivity, and set to "high' if the DUST MONITOR and ODOUR MONITOR is constantly
green to increase sensitivity.
1
With the unit OFF, press the Fan Speed Button for 3 seconds.
The Fan Speed Indicator Lights will display the currently set sensor sensitivity level. The
factory setting is Standard, indicated by the MED light.
2
Press the Fan Speed Button to set the desired sensor sensitivity.
Refer to the diagram on the right to select the desired sensor sen-
sitivity level.
3
Press the Power OFF Button.
Note that if the Power OFF Button is not pushed within 8 seconds
of adjusting sensor sensitivity, the setting will be saved automati-
cally. The sensor sensitivity setting will be saved even if the unit is
unplugged.
Refer to the diagram on the right to select the
desired brightness on the front panel.
The lights on the front panel are brighter.
The lights on the front panel are brighter.
｢ ｣
The lights on the front panel are darker. The lights on the front panel are darker.
｢ ｣
The lights on the front monitor turn off.
The lights on the front monitor turn off
｢ ｣
E-10
Flashing
Sensor
Fan Speed
Detection
Indicator
sensitivity
Light
High
Standard
Low