Publicidad
Idiomas disponibles
Idiomas disponibles
Indication for Flash memory
• Abnormal current is run to the USB port (an error
message may be displayed if the USB device that is not
compatible with the unit is connected).
Flash memory malfunction.
- Connect another flash memory.
• A USB device that is not supported by the unit is
connected.
- Connect a USB device that is supported by the unit.
NO DEVICE
• Flash memory is not connected or not recognized.
- Make sure the flash memory device is correctly
connected and the cable is not excessively bent.
• No song (file) is stored in the flash memory.
- Connect the flash memory device after storing songs
(files).
• A sampling rate/bit rate not supported by the unit is used.
- Use a sampling rate/bit rate that is supported by the
unit.
• A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
NO SUPPORT
• Text information that is not recognizable by the unit has
been input.
- Use a flash memory device with input text information
that is supported by the unit.
24
-EN
Indication for iPod Mode
• The iPod/iPhone is not connected or not recognized.
- Make sure the iPod/iPhone is correctly connected
(refer to "Connections" on page 28).
Make sure the cable is not bent excessively.
• There are no songs in the iPod/iPhone.
- Download songs to the iPod/iPhone and connect to this
unit.
• Communication error.
- Reset the iPod.
- Check the display by reconnecting between the iPod/
iPhone and this unit, using the iPod/iPhone cable.
• Caused by the iPod/iPhone Software Version not being
compatible with this unit.
- Update the iPod/iPhone Software Version to be
compatible with this unit.
• The iPod/iPhone is not verified.
- Reset the iPod.
- Try another iPod/iPhone, if available.
• Power surge error.
- Excessive voltage/current is supplied to the iPod/
iPhone.
- Try another iPod/iPhone, if available.
- Turn the ignition key off, and then set to ON again.
Publicidad
