Descargar Imprimir esta página

EMAK OLEO-MAC PW 300 HC Manual De Instrucciones página 29

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 54
PROBLEMS
No water comes out
from the nozzle (20).
The water cleaner stops
during the operation.
R o t at i n g t h e m a i n
switch (2), the motor
hums but does not start.
The water cleaner does
not supply hot water.
CAUSES
Water missing.
Water nozzle clogged.
A safety device of the system
to which the water cleaner is
connected (fuse, differential
switch, etc.) has triggered.
The amperometric protection
device has cut in.
The electrical system and/or the
extension are not suitable.
The Diesel in the tank is below
the minimum level.
The Diesel filter is clogged.
SOLUTIONS
Check that the tap of the water network is
completely opened.
Clean and/or replace the nozzle according
to what mentioned in the section
"Features and technical specifications" .
Reset the protection device.
In case of a new triggering, do not use
the water cleaner and apply to a Skilled
Technician.
Observe what mentioned in the section
"Safety devices" .
Observe what mentioned in the section
"Checks and connection to mains
electricity supply" .
Add Diesel
Observe what mentioned in the section
"Special maintenance" .
GB
29

Publicidad

loading

Este manual también es adecuado para:

Efco ip 3000 hs