Replacing The Battery - Spectroline CLARITY 365 Serie Manual Del Operador

• Lithium-ion batteries are subject to disposal and recycling regulations that vary by country
and region. Always check and follow your applicable regulations before disposing of any
battery.
CHARGING THE CLARITY 365
The CLARITY 365 flashlight kit comes equipped with a battery charger available in
several different voltages as well as a USB charging adapter. See Replacement Parts
Section for full listing.
• Connect the charging dock to the charging cord set with the 12V adapter prong and plug the
AC into a wall outlet.
• Charge the CLARITY 365 flashlight in the charging dock via the AC plug or USB connector.
• Leave the CLARITY 365 in the charging dock for 6.5 hours when fully depleted. The lamp will
blink green when charging, then turn off when fully charged.
NOTE: Keep the charging dock free from contaminants or it may interfere with charging. Place it
wherever appropriate.

REPLACING THE BATTERY

The Li-ion battery must be replaced over time. It will deteriorate from repeated use. Turn the
flashlight upside down and twist off the induction tail cap counterclockwise. Remove the induction
tail cap from the flashlight, and then remove the battery from the flashlight. There are no orientation
requirements for the battery. See Replacement Parts section and contact Customer Service for
more details.
NOTE: Be sure to use genuine CLARITY 365 (SPN-CLR365) replacement parts. Using another
manufacturer's replacement parts could affect product performance and will void the warranty.
MEASURING UV-A INTENSITY
To ensure that your CLARITY 365 flashlight is operating at the required UV-A intensity, it
should be checked periodically. The AccuPRO™ XP-2000 combines the functionality of a UV
and visible light radiometer/photometer, and is specially designed to measure UV irradiance
with wavelengths of 320–400nm (with peak at 365nm) and visible light from 460–675nm
(with peak at 555nm). Other suitable meters include the AccuMAX™ XRP-3000 radiometer/
photometer kit, using dual-wavelength UV-A and VIS sensor detectors to accurately mea-
sure the irradiance of a light source. The AccuMAX™ XR-1000 digital readout unit with
the XS-365 UV sensor or the DM-365XA digital readout unit can also be used for UV-A
measurement.
WARRANTY
The warranty policy for the CLARITY 365 flashlight is provided on the Certificate of Limited
Warranty enclosed separately with each unit. The serial number for your item is located on the
side of the induction tail cap.
3