Safety Tips
Position on a flat, stable surface.
A service agent/qualified technician should carry out installation and any repairs if required.
Do not remove any components or service panels on this product.
Consult Local and National Standards to comply with the following:
o Health and Safety at Work Legislation
o BS EN Codes of Practice
o Fire Precautions
o IEE Wiring Regulations
o Building Regulations
DO NOT use jet/pressure washers to clean the appliance.
DO NOT use the appliance outside.
DO NOT store products on top of the appliance
Always switch off and disconnect the power supply to the unit before cleaning.
Keep all packaging away from children. Dispose of the packaging in accordance with the
regulations of local authorities.
If the power cord is damaged, it must be replaced by a Buffalo agent or a recommended qualified
technician in order to avoid a hazard.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience or knowledge, unless they have been
given supervision or instruction concerning the use of the appliance by a person responsible
for their safety
Children should be supervised to ensure that they do not play with the appliance.
This appliance must NOT be installed where persons bathing could reach
This appliance must NOT be installed within 1.8M of a wet zone (bath, sink, shower etc)
This appliance must NOT be installed where persons could reach when taking a shower
DO NOT cover the air inlet
Product Description
GD847 -
Buffalo Automatic Hand Dryer - Stainless Steel
Pack Contents
Buffalo Automatic Hand Dryer
Instruction Manual
3 |
P a g e