Fender TBP-1 Instalación Y Funcionamiento página 7

Front Panel Features:
• Fender ® passive tone stack (remember passive
means CUT ONLY)
• • Delivers that creamy tube tone
• • Volume, Bass, Mid & Treble controls for the
"clean" sound
• • Pull Deep and Bright boost switches
• • A (roughly) flat tone would be with the EQ set
Bass: 2, Mid: 10, Treble: 2, with no Deep or
Bright boosts active
• Tube Overdrive section
• • Gain, Volume and Blend
• • This channel sits on top of the clean (which
preserves the warm clean pillow under the
overdrive)
• • Blend adjusts the clean vs. dirty ratio of the
tone (can be set "touch-sensitive")
• • Footswitchable
included)
• Vari-Q™ section – A smart semi-parametric EQ
• • Cutting frequencies automatically DECREASES
the width of the Q for a narrow, defined cut
(notch)
• • Boosting frequencies automatically INCREASES
the width of the Q for a broader, more musical
boost
• • This intelligent Q control keeps "on the fly"
operation simple and effective
• • Footswitchable
included)
• Room Balance – Global EQ shift for cabinet/stage
response
• • Clockwise cuts lower frequencies while
simultaneously boosting upper frequencies
• • Counter-clockwise boosts lower frequencies
while simultaneously cutting upper frequencies
• • Room Balance Does NOT affect BALANCED
LINE OUT output (soundman gets unaltered
signal)
w w w w w w . . f f e e n n d d e
Feature Set
(4-button footswitch
(4-button footswitch
e r r . . c c o o m m
• Master Volume – One level control that affects
everything (except Balanced Line Out, Tuner and
FX Send)
• Mute
• • Cuts all signal except for the Tuner and FX
Send
• • Footswitchable
included)
Rear Panel Features:
• BALANCED LINE OUTPUT with Ground Lift and
Pre/Post switches and Level control
• Jensen ® Line Out Transformer (THE output
transformer for maintaining a clean Balanced Line
Out signal)
• Tuner Send (always on, even when the MUTE is
engaged)
is
• Effects Loop with Trim control and level shift
switch (can also be used as an adjustable boost
control)
• • Footswitchable
included)
• Bi-amp low and high sends with active crossover
(as big as you need it to be)
• Full-Range Main Output
is
• Footswitch input (4-button controls: Overdrive, FX
Loop, Vari-Q™ and Mute)
• Additional Instrument Input on the back (in case
your rack setup prefers having the input
connection in the back)
w w w w w w . . m m r r g g e
T T B B P P - - 1 1
T T B B P P - - 1 1
(4-button footswitch
(4-button footswitch
e a a r r h h e e a a d d . . n
7
is
is
n e e t t