Installation Procedure - Taramps Electronics HV40.000 CHIPEO Manual De Instruccion

Installation Procedure

1 - Follow all procedures described below;
2 - If you do not follow the proper procedures by qualified professionals, Taramps is exempled
of any responsibility;
3 - Insulate completely all system connections, this avoiding electrical contact with the
vehicle chassi;
4 - Accessories and peripherals (such as Head Units, equalizers, crossover or other equipment
requiring power at 12 volts) should be eliminated from the original vehicle connections. The
equipment will be supplied by the of auxiliary batteries bank, designed according to system
needings;
5 - Circuit breakers must be installed in a visible and easily access place for operating, and
system maintenance;
6 - The batteries must be insulated once installed, to avoid electric shock, sparks and/or
damage to vehicle;
7 - All connections should be made with all circuit breakers off.
TURNING ON THE AMPLIFIER
1 - Check that any system is not shorted or in contact with the chassis of the vehicle;
2 - Check carefully if the negative points of high voltage batteries bank and 12.6 VDC battery
negative point are connected together;
3 - Connect the speakers in its output;
4 - Make sure that your batteries are properly charged;
5 - Keep the volume control (Level) at the minimum;
6 - Turn on the remote to activate the preamp;
7 - After checking the preamplifier, disconnect the remote, activate the circuit breakers and
turn-on the remote again;
8 - Set all volume settings, frequency cuts and enjoy all the advantages of your new amplifier.
CARING OF YOUR SOUND SYSTEM
1 - After the use of the sound system, turn off all circuit breakers;
2 - Never move the vehicle with activated circuit breakers;
3 - Do not connect the battery charger with the sound system in operation;
4 - Do not add any other battery charger; Use only the specified charger.
5 - Do not start the vehicle engine with the sound system in operation;
6 - The engine starting (ignition) is only allowed once all circuit breakers are turned off.
NOTE:
Failure to comply with any of the above procedures fully exempts Taramps from any liability
for the risks of its use. So for you can take advantage of this high technology, high quality and
powerful amplifier, be sure to follow step by step all safety procedures, otherwise it could
implies the loss of warranty.
For further information please contact our Technical Department to solve all doubts.
All electrical and electronic equipment installation must be made by qualified and trained
professionals.
"Your life is valuable. Avoid accidents. Depending on the severity of an electric shock, it can
cost your life".
03