Whirlpool 4KWED4915 Manual De Uso Y Cuidado página 13

Troubleshooting
First try the solutions suggested here to possibly avoid the cost of a service call.
If you experience
Cycle time too short
Lint on load
Stains on load or drum
Loads are wrinkled
Odors
Load is too hot
Latin America Service
For other countries in Latin America, see our Warranty Card Latin America and visit our Whirlpool Latinoamerica website
Possible Causes
Automatic cycle ending early.
Lint screen clogged.
Dryer fabric softener not properly used.
Load not removed from dryer at the end
of the cycle.
Dryer tightly packed.
You have recently been painting, staining,
or varnishing in the area where your dryer
is located.
The electric dryer is being used for the
first time.
Laundry items removed from the dryer
before the end of the cycle.
A high temperature cycle was used,
or a separate temperature control was
set on High.
www.whirlpool-latam.com.
Solution
The load may not be contacting the sensor strips.
Level the dryer.
Use Timed Dry for very small loads. Change the Dry Level
setting on Automatic Dry cycles.
Increasing or decreasing the Dry Level setting will change
the amount of drying time in a cycle.
Lint screen should be cleaned before each load.
Add dryer fabric softener sheets at the beginning of the
cycle. Fabric softener sheets added to a partially dried
load can stain your garments.
Drum stains are caused by dyes in clothing (usually blue
jeans). These will not transfer to other clothing.
Select Wrinkle Shield feature to tumble the load without
™
heat to avoid wrinkling.
Dry smaller loads that can tumble freely to reduce the
chance of wrinkles forming.
If so, ventilate the area. When the odors or fumes are gone
from the area, rewash and dry the clothing.
The new electric heating element may have an odor.
The odor will be gone after the first cycle.
Allow Cool Down cycle to finish before removing
laundry from dryer. All cycles are cooled slowly to reduce
wrinkling and make it easier to handle. Items removed
before Cool Down may feel very warm.
Select a lower temperature and use an automatic drying
cycle. These cycles sense the temperature or the moisture
level in the load and shut off when the load reaches the
selected dryness. This reduces overdrying.
13