Installation; Installing The Outside Station; Installing The Extra Camera (Option); Wiring - Extel LEVO Serie Instrucciones De Uso E Instalación

4. INSTALLATION

Note: If you try the system before installing it, make sure the outside unit and monitor are not in the same room,
otherwise the videophone will emit piercing feedback noise (Larsen effect)
a. Installing the outside station
1. Remove the screw under the outside station
2. Tip the outside station forward
3. The panel lens must be placed at a height of about 1.60 m.
4. Place a silicone seal between the shield and the wall to avoid water running inside. *Do not use acetic acid
based silicone (vinegar smell).
7. Engage the outside station onto its rain shield
Important :
Tip:
we recommend passing the cables through a protective sleeve to protect them from impacts and the
weather.
b.
1. Fasten the wall mounting (2) so that the monitor screen is at a height of about 1.60m.
2. Connect the two outside station wires and the 2 power supply wires (ch. 5.a) according to the wiring diagram
3. Position the monitor on its wall mount.
4. Only connect the 230 V~ power supply to the modular adapter after having connected the outside station (on
Please, reserve 5cm each side of MODULO B when install
Make sure the power supply polarity is correct
c. Installing the extra camera (option)

5. WIRING

To avoid disturbances and malfunction risks, do not pass the wire from the videophone through the same sheaths
as electric wires.
Caution: never double wires to increase their size.
a. Connecting the videophone
Use the following wires:
1. Connect the wires following the wiring diagram (fig. 6).
2. To connect the camera, only 2 wires are needed for all functions: ring tone, video image, intercom and opening
controls (door opener and automation).
GB3
th wires up to 25 m
2 from 25 to 100 m
CFI EXTEL LEVO - 12/2014