Geutebruck GeViScope-HS/R Manual De Operación página 43

The machine reboots.
Now the machine starts the recovery process. The start screen offers two buttons: CONTINUE and
CANCEL. CANCEL ends the recovery process immediately and the command line is called up. With
CONTINUE, you enter the recovery process.
Select CONTINUE to start the process and to rest the GeViScope to the same condition as on delivery.
After conclusion of the installation the computer reboots. In so-doing, it is returned to its state on
delivery.
After finishing the recovery, the BIOS settings have to be reset for safety reasons:
Switch on the machine.
When the start screen appears, press F2. The boot menu appears.
Good to know...
On machines with a BIOS password, you will be asked to enter it before the start of the BIOS setup
(after pressing F2):
Go to the BOOT menu.
Under
Boot Device Priority
, set the top entry to
<Hard Disk Drive>.
17