Cleaning The Lint Filter - Koenic KTD 9322 A3 Manual De Instrucciones

Additional functions
Delayed drying (Startzeitverzögerung)
If you wish to postpone the
Fig.
8
drying process, a time delay can
be set. Use the delay button
(Startzeitverzögerung) to set a
postponed start between 1-12 hours.
The dryer starts the drying process
after the preset time has elapsed.
1. Fill the drum with your clothes and
close the door.
2. Switch on the appliance with the
on / off
3. Chose your program and an
additional function if needed (e.g.
Anti-Crease).
4. Push the button Delay
(Startzeitverzögerung) for as
many times as needed to set the
time delay in hours (H) which is
indicated in the display.
5. Push the start / pause button
The dryer is activated and will start
the drying process once the preset
time has elapsed.
6. Push the start / pause button
to pause the timer. For cancellation
push on / off
Child protection (Kindersicherung)
Once the child protection is activated,
Fig.
9
the setting cannot be changed. In that
case the dryer can only be switched off
by pushing the on / off button
child protection can only be activated
if the dryer operation was started or is
running either directly or by time delay.
1. Activation: Press the
NACHTMODUS and
TROCKENGRAD buttons at once
and for approx. 3 seconds. The
corresponding LED
indicates the child protection.
2. De-activation: Press again the
NACHTMODUS and TROCKENGRAD
buttons at once and for approx. 3
seconds. The corresponding LED in the
display turns off.
IM_KTD9322A3_200603_V05_HR.indb 33 IM_KTD9322A3_200603_V05_HR.indb 33
switch.
.
switch.
. The
of the display
Anti-crease function
This function is used to minimize
Fig.
10
the appearance of crease after the
drying process has finished. The anti
crease function is set by default
and for 60 minutes but not available
for the programs ZEITVORWAHL
(Auffrischen, Kalt) and Wolle. The
drum rotates intermittently in order to
minimize formation of crease.
• Press the anti-crease
(KNITTERSCHUTZ) button to set
the anti crease time to 30, 60 or
90 minutes for the corresponding
programs.
Cleaning and care
Warning
• When cleaning, never use solvents or
abrasive materials, hard brushes, metallic
or sharp objects. Solvents are harmful to
human health and can attack plastic parts,
while abrasive cleaning mechanisms and
tools may scratch the surface(s).
• Switch off the tumble dryer and let it cool
down completely before cleaning.
• Clean the exterior surfaces of the product
with a slightly damp cloth and dry them
well. Make sure that no water enters the
product interior (e.g. at the switches).

Cleaning the lint filter

Fig. Pull out the filter and open it. Remove
11
lint and fibers by hand. Wash the filter
with tap water in order to remove
remaining lint or particles. Dry it well
afterwards.
Reassembling is done in reverse order.
English
33
3/6/2020 5:07 PM 3/6/2020 5:07 PM