Measuring Diodes - Facom 711 Guía De Instrucciones

Measuring diodes

Place the switch on the diode function
Place the probe tips on the terminals of the component to be
tested.
In the reverse direction the display gives the junction value in
volts
(threshold voltage)(resolution 1 mV, accuracy
circuit current : 0.8 mA)
In the forward direction the display shows the battery
voltage. Save the value if necessary by pressing the
key. With this function it is possible to test conventional
diodes, light emitting diodes and any other type of semi-
conductor having a junction corresponding with a direct
voltage of less than 3 Volt.
Protection: 500 Volt rms and 750 Volt peak.
.
%L 15mV, short
: ± 2
±
HOLD
19