Publicidad
Idiomas disponibles
Idiomas disponibles
DIP-SWITCHES
n°1
ON:
after opening, the gate automatically closes when the delay set on the T.C.A. trimmer
expires.
OFF:
automatic closing disabled.
n°2
ON:
with automatic closing enabled, a sequence of open/close commands causes the gate
to OPENCLOSE-OPEN-CLOSE etc.
OFF: in the same conditions, the same command sequence causes the gate to OPEN-
STOP-CLOSESTOP-OPEN-STOP (step-by-step).
n°3
ON:
(no reverse) during opening the gate ignores any closing commands.
OFF:
the gate's behavior depends on the position of dip switch No.2.
n°4
with software version 1.04 and previous versions
ON:
the deceleration function is on (for motors with limit switch only).
OFF: the deceleration function is off.
with software version 1.05 ÷ 3.00, see table 1.
with software version 3.10 onwards, see table 2.
n°5
ON:
preflashing enabled, each time the gate is operated the light starts flashing 3 seconds
before the gate begins to move.
OFF: when the gate is started, it will move immediately.
n°6
ON:
monostable function of the CH2 control relay (terminals 9 and 10) enabled.
OFF: bistable (or STEP-BY-STEP) function of the CH2 control relay (terminals 9 and 10)
enabled.
n°7
ON:
with dip-switch 6 ON (monostable function), the N.O. contact remains closed for 180
secs. (fixed invariable delay for the timed control of the lights).
OFF: with dip-switch 6 ON (monostable function), the N.O. contact remains closed for 2
secs. (fixed invariable delay for commanding a second automatic system).
with software version 3.10 onwards:
n°6 OFF and n°7 OFF:
n°8
with software version 1.04 and previous versions
not used.
with software version 1.05 ÷ 3.00:
ON:
encoder enabled (see table 1)
OFF: encoder disabled.
with software version 3.10 onwards:
ON:
encoder enabled (see table 2)
OFF: encoder disabled.
n°9
ON:
pressure-sensitive edge on.
OFF: pressure-sensitive edge off.
n°10
ON:
internal push-button panel off. The OPEN/CLOSE and STOP buttons on the lid of the
automation are off. Therefore it is not necessary to short circuit the terminals.
OFF: internal push-button panel on. The OPEN/CLOSE and STOP buttons on the lid of the
automation are on.
IMPORTANT:
Each pair of terminals attached to an NC contact that is not in use must be short-circuited in order to
ensure the proper operation of the board.
The input related to the pressure-sensitive edge must not be short circuited. The device is turned off
by setting dip 9 to OFF.
The door's earthing system must comply with current standards. The manufacturer will accept no li-
ability for any damage deriving from failure to comply with this requirement.
Gate open contact: the contact activates on gate opening, remains active
during the opening time, during the TCA and during closure again. It is
deactivated once the gate has completed closure.
K892M
15
Publicidad
