Installation Instructions - Start-Up; Water Discharge - Bertos PLE80BE Manual De Instrucciones

START-UP
Before beginning installation, remove all packaging from
the appliance. Some parts are protected with an
adhesive film which should be carefully removed.
Any remnants of glue should be thoroughly cleaned
using suitable substances such as benzine. Under no
circumstances should abrasive substances be used.
Fit the legs to the appliance; the appliance must be
levelled using a spirit level. Slight irregularities can be
levelled by adjusting the feet themselves.
With table models, make sure that the base chosen is
capable of supporting the weight of the appliance. The
main switch or plug should be located in the vicinity of
the appliance and easy of access. We recommend
installing the machine under a range hood so that all
the fumes are removed as quickly as possible. If the
appliance is to be installed near walls, dividing walls,
kitchen equipment or decorative pannelling, these should
be in non-inflammable material or covered with non-
inflammable material.
Make sure that all fire prevention standards and safety
precautions are strictly adhered to.
Warning!
With Top models, carefully measure the distance between
the appliance and the edge of the base (Fig. 1).
Legal and technical requisites
When installing the appliance, the following safety
standards must be adhered to:
- Local accident prevention standards
- Current CEI standards.
Installation
Installation, start-up and maintenance should only be
carried out by expert personnel. All work required to
install the appliance should be carried out in compliance
with all local standards and regulations. The
manufacturers decline all responsibility where poor per-
formance is due to incorrect installation in disregard of
the above conditions.
INSTALLATION INSTRUCTIONS
ELECTRIC WATER GRILL 8
Warning!
Connect the appliance using an omnipolar device
for disconnecting the appliance from the mains. This
device must have a minimum aperture of 3 mm
between contacts.
Wiring
When choosing the lead wire, make sure it has the
following characteristics: it should be at least of the H05
RN-F type and its section should be large enough for
the appliance (see "Technical specifications and
dimensions", page 2).
Cable entry is to the left, on the back. The terminal board
is at the front, behind the control panel.
Pass the wire through the core hitch and wire clamp,
plug the leads into their terminals on the board and
secure them. The earth lead must be a little longer than
the others so that it is the last lead to disconnect if the
wire clamp breaks.
Unipotential
Connect the appliance to an unipotential system. The
connection screw is located on all top models at the
Unipotential
back on the right hand side, wile in other models it is
located underneath the appliance on the right hand
Connect the appliance to an unipotential system. The
side. It is labelled.
connection screw is located on all top models at the back
on the right hand side, while in other models it is located
Water mains connection
underneath the appliance on the right hand side. It is
labelled.
Connect the water supply pipe to the mains with a
mechanical filter and shutoff valve.
Before connecting the filter, allow a certain amount of
Warning!
water to flow out to flush debris from inside the pipe.
The manufacturers cannot be held responsible for

Water discharge

any damage due to inadequate or incorrect
Connect the appliance water discharge pipe to the
installation. Under such circumstances the
mains.
guarantee will be considered null and void.
Warning!
The manufacturers cannot be held responsible for any Start-up
damage due to inadequate or incorrect installation.
Before using the appliance for the first time, thoroughly
Under such circumstances the guarantee will be
clean out the oil bath (see paragraph entitled "Cleaning
considered null and void.
and Taking Care of the Appliance").
Check that the appliance is connected up properly and
Start-up
start according to instructions overleaf.
Before using the appliance for the first time,
thoroughly clean out the oil bath (see paragraph
entitled "Cleaning and Taking Care of the Appliance").
Check that the appliance is connected up properly
and start according to instructions overleaf.
GB