Troubleshooting - EGO STA1500 Manual Del Operador

TROUBLESHOOTING

EN
PROBLEM
Line trimmer fails
to start
Line trimmer stops
while cutting.
12
LINE TRIMMER ATTACHMENT — STA1500
CAUSE
◾
The battery pack is not attached
to the power head.
◾
No electrical contact between
the power head and the battery
pack.
◾
The battery pack is depleted.
◾
The lock-off lever and
trigger are not depressed
simultaneously.
◾
The guard is not mounted on the
trimmer, resulting in an overly
long cutting line and motor
overload.
◾
Heavy cutting line is used.
◾
The motor shaft or trimmer head
is bound with grass.
◾
The motor is overloaded.
◾
The battery pack or line trimmer
is too hot.
◾
The battery pack is
disconnected from the tool.
◾
The battery pack is depleted.
SOLUTION
◾
Attach the battery pack to the power head.
◾
Remove battery, check contacts and reinstall the
battery pack until it snaps into place.
◾
Charge the battery pack with EGO chargers listed
in this manual.
◾
Press down the lock-off lever and hold it, then
depress the trigger to turn on the line trimmer.
◾
Remove the battery pack and mount the guard on
the trimmer.
◾
Use recommended nylon cutting line with diameter
no greater than 0.095 in. (2.4 mm).
◾
Stop the trimmer, remove the battery, and remove
the grass from the motor shaft and trimmer head.
◾
Remove the trimmer head from the grass. The
motor will recover when the load is removed. When
cutting, move the trimmer head in and out of the
grass to be cut and remove no more than 8 inches
of length in a single cut.
◾
Allow the battery pack or trimmer to cool until the
temperature drops below 152°F (67°C).
◾
Re-install the battery pack.
◾
Charge the battery pack with EGO chargers listed
in this manual.