Charging The Battery; Removing The Fastener Guide; Inserting The Fastener Guide - Hilti BX 3-ME Manual De Instrucciones

Noise and vibration information (measured in accordance with EN 60745-2­16)
Typical A­rated emission sound pressure level, L
into concrete and steel)
Typical A­rated emission sound pressure level, L
into concrete and steel)
Uncertainty for the specified sound levels, K
Total uniaxial vibration values (in z-direction)
Vibration emission value, a
steel)
Uncertainty, K
5 Preparing the tool for use

5.1 Charging the battery

1. Remove the battery. → page 25
2. Charge the battery in accordance with the information provided in the operating instructions for the
charger.
5.2 Inserting the battery
Note
In order to achieve maximum battery lifetime, replace the discharged battery with a fully charged
battery as soon as you notice a clear drop in battery performance.
1. Check that the contacts on the battery and on the tool are free from foreign objects.
2. Fit the battery and make sure that it is heard to engage.
◁ Once the battery has been fitted, the charge status LEDs light for a short time.
CAUTION
A falling battery presents a hazard. If the battery is not secured correctly it may drop out and fall
while the work is in progress.
▶ Always check that the battery is securely seated.
3. Check that the battery is securely seated in the fastening tool.

5.3 Removing the fastener guide

1. Switch the fastening tool off. → page 24
2. Remove the battery. → page 25
3. Pull the nail pusher down until it engages.
4. Unload the magazine. → page 25
5. Slide the fastener guide locking catch as far as it will go in the direction of the arrow.
◁ The fastener guide will be released.
6. Remove the fastener guide.

5.4 Inserting the fastener guide

1. Switch the fastening tool off. → page 24
2. Remove the battery. → page 25
3. Pull the nail pusher down until it engages.
4. Unload the magazine. → page 25
5. Slide the fastener guide locking catch as far as it will go in the direction of the arrow and hold it in this
position.
6. Slide the fastener guide into the nosepiece until it is heard to engage.
7. Release the fastener guide locking catch.
◁ The fastener guide jumps to the middle position.
8. Grip and pull the fastener guide to check that it is securely seated.
22 English
Printed: 24.08.2016 | Doc-Nr: PUB / 5242878 / 000 / 03
WA
pA
(when driving nails into concrete and
h
2
(when driving nails 100 dB
(when driving nails 89 dB
3 dB
2.5 m/s²
1.5 m/s²