Craftsman 917.387560 Manual De Instrucciones página 17

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
- See appropriate
section
to a Sears
Parts & Repair
Center.
PROBLEM
CAUSE
Loss of power
1. Rear of mower housing or
Poor cut -
uneven
Excessive
vibration
Starter
rope
hard to pull
in manual
unless
directed
blade dragging
in grass.
2.
Cutting
too much grass.
3.
Dirty air filter.
4.
Buildup
of grass,
leaves,
and trash under mower.
5.
Too much oil in engine.
6.
Walking
speed
too fast.
1. Worn,
bent or loose
blade.
2.
Wheel
heights
uneven.
3.
Buildup
of grass,
leaves
and trash under mower.
1. Worn,
bent or loose
blade.
2.
Bent engine
crankshaft.
1. Engine
flywheel
brake
is on
when control
bar is released.
2.
Bent engine
crankshaft.
3.
Blade adapter
broken.
4.
Blade dragging
in grass.
Cutting
height too low.
Lift on blade worn off.
Catcher
not venting
air.
Grass
is too high or wheel
height
is too low.
2.
Rear of lawn mower
housing
or cutting
blade
dragging
in grass.
3.
Grass
catcher
too full.
4.
Handle
height
position
not
right for you.
CORRECTION
1. Raise cutting height.
2.
Raise cutting
height.
3.
Clean/replace
air filter.
4.
Clean
underside
of mower
housing.
5.
Check
oil level.
6.
Cut at slower walking
speed.
1. Replace blade. Tighten
blade bolt.
2. Set all wheels at same
height.
3. Clean underside of
mower housing.
1. Replace blade. Tighten
blade bolt.
2. Contact a Sears or other
qualified service center.
1. Depress
control
bar to
upper
handle
before
pulling
starter
rope.
2.
Contact
a Sears
or other
qualified
service
center.
3.
Replace
blade adapter.
4.
Move lawn mower
to cut
grass or to hard surface.
Grass
catcher
1.
1. Raise cutting
height.
not filling
2.
2.
Replace
blade.
(If so equipped)
3.
3.
Clean
grass catcher.
Hard to push
1.
1. Raise cutting
height.
2.
Raise rear of lawn mower
housing
one (1) setting
higher.
3.
Empty
grass catcher.
4.
Adjust
handle
height to suit.
17

Publicidad

Tabla de contenido
loading

Tabla de contenido