Frame Rate Setting
1.
In the setting mode, press
2.
Press
or
3.
Press
or
confirm and exit.
Time Stamp Setting
1.
In the setting mode, press
2.
Press
or
3.
Press the
confirm and exit.
Event Playback
1.
In the setting mode, press
2.
See the user instruction manuals on Playback of Video/Picture, Deleting Video/Picture, and Deleting Folder for guidance.
Problem
The monitor and the handle do not start
Monitor does not charge
Image too dark or bright
Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect power supply before service.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation. Changes or
modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with the following directives:
Requirements
Radio spectrum, Article 3.2
EMC, Article 3.1 (b)
Safety, Article 3.1(a)
Health, Article 3.1 (a)
-20-
or
button to select 'RECORDER SETTING', and then press OK button.
button to select 'Frame Rate' and then press OK button.
button to toggle between different frame rates. Once your desired rate is selected, press OK button to
or
button to select 'RECORDER SETTING', and then press OK button.
button to select "Time Stamp" and then press OK button.
and
buttons to toggle between On and Off. Once your desired selection is made, press OK button to
or
button to select 'EVENT PLAYBACK', and then press OK button.
1.
2.
1.
2.
1.
2.
TROUBLESHOOTING
Possible Causes
Monitor not charged.
Batteries need charging.
Adapter cable not attached
properly
Adapter not connected to
power
LEDs near camera need
adjustment
Monitor display needs
adjustment
FCC INFORMATION
Standars
ETSI EN 300 440-2 V1.4.1
ETSI EN 301 489-1 V1.8.1
ETSI EN 301 489-3 V1.4.1
EN 60065:2002 + A1:2006 + A11:2008
EN 50371:2002
Likely Solutions
1.
Charge the monitor
2.
Replace the batteries in
handle assembly
3.
Press the reset button to start
1.
Make sure the adapter cable
is connected between the monitor and the
adapter.
2.
Make sure the adapter is
securely plugged into wall socket.
1.
Use dial on control handle to
adjust brightness of LEDs.
2.
Use contrast and brightness
buttons on monitor to adjust image.